Here you can find pre-built calculation and design templates from all kinds of different disciplines and areas. You can use them as is or duplicate them into your own workspaces and make them your own!

Templates

Free-To-Use Calculation Templates: Save Time and Effort with CalcTree. Get Access to a Wide Range of Templates for Your Calculations. Start using now!

Calculation templates

Select a jurisdiction to use suitable calculation templates:

AS/NZ

Europe

Beam Analysis Calculators

Beam Analysis using Macaulay's Theorem

Beam Analysis using Anastruct

2D Truss Analysis using OpenSeesPy

Column Buckling Calculator

Sample Project

Concrete Column P-M Diagram Calculator

Structural Engineering

Enhance your knowledge and stay up-to-date with the latest trends and innovations in structural engineering with our articles and resources. Visit now

Structural Engineering Calculators

Concrete Beam Designer to AS3600

Concrete Retaining Wall to AS4678

Concrete Shear Wall to AS3600

Concrete Wall to AS3600

Concrete Slabs to AS3600

Neutral Axis Calculator: RC Section to AS3600

Concrete Column Designer to AS3600

Concrete Slab-on-grade Designer to AS3600

Concrete Rectangular Footing Designer to AS3600

Concrete Punching Shear Calculator to AS3600

Reinforcement Development Length Calculator to AS3600

Steel Beam and Column Designer to AS4100

Fillet Weld Group Calculator to AS4100

Bolt Group Calculator to AS 4100

Steel Web Plate Connection to AS4100

Steel Moment End Plate Connection to AS4100

Steel Flexible End Plate Connection to AS4100

Timber Beam Calculator to AS1720.1

Timber Column Calculator to AS1720.1

Timber Joints to AS1720.1

Load Combinations to AS1170.0

Wind Load to AS/NZS 1170.2

Truss Analysis and Design

Check out CalcTree's library of structural engineering calculations to AS/NZ building and design codes here.

Structural engineering calculations to AS/NZ codes and standards

Click below for a complete guide to slab analysis and design following the Australian Standards.

Design Guide: Concrete Slabs to AS3600

The design guide is accompanied by three calculators, that perform the analysis and design of reinforced concrete slabs, either one-way or two-way spanning, or flat slabs. 

Concrete One-way Slab Calculator to AS3600

Concrete Two-way Slab Calculator to AS3600

Concrete Flat Slab Calculator to AS3600

Pack of concrete slab analysis and design to Australian Standards, with a complete design guide and three calculators: one-way, two-way or flat slab

This calculator performs the analysis and design of reinforced concrete two-way spanning slabs supported on four sides by beams or walls.

This calculator performs the analysis and design of reinforced concrete two-way spanning slabs supported by columns, i.e. a flat slab. 

Complete design guide following the requirements and procedures of AS3600 for concrete slabs: one-way slab, two-way slab and flat slabs

Design Guide: Concrete Slabs to Australian Standards

This calculator performs the analysis and design of reinforced concrete one-way spanning slabs. 

Concrete Slabs to AS3600

Related Resources